Similar
to Plan #001 (Adjustable Angle Crosscut with Drop Panel), this crosscut jig has
a shorter 18" fence and uses fewer components to achieve comparable functionality.
The T-Track Plus and user made stop positioner provide repeatable crosscut length
control. The rear mounted T-Track Regular combined with a pair of Build-It Brackets
and the twin T-Slot Panel Connectors allow for unlimited adjustment of the fence
angle. Begin
by adding a Miter Slider to a small Build-It Panel. Place in your table saw's
miter slot and adjust for
a good fit, then add a T-Slot Panel Connector to
each edge. Increase the platform width to cross the line of cut by adding the
large Build-It Panel. Trim to the blade as described in Steps 3 & 4 shown
on the reverse side of your Build-It Panel's wrapper then mount the cutoff from
the large panel to the opposite side of the small panel. Make the 18" fence
and stop positioner as shown in Fig. 3 and Detail 3A using 18" T-Track Regular
and T-Track Plus components then attach to the T-Slot Panel Connectors using a
pair of Built-It Brackets. Now you can adjust the fence to the desired angle,
clamp your workpiece in place and begin your project's crosscut requirements with
confidence.
